Legrand Wiremold Plastic CordMate Kit White

GARDNER BENDER Butt Splice Kit 2-8 AWG; 1/Cd

Butt Splice Kit is used for waterproof installation or repair of #8 - #2 AWG copper cable. Easy to use polyolefin seals with heat gun or torch eliminating messy epoxies, tapes or mastics. Instructions: Slide heat shrink tubing over one conductor. Remove 5/8" insulation from conductors to be spliced. Insert stripped conductor in the butt splice. Tighten set screw to the lb per inch recommendations on the packaging and check for continuity of wire. Move heat shrink tube over splice and center. Heat tubing with torch or heat gun (MSTR-TORCH). Tubing shrinks at 350 F. Start in the middle of the tube, apply heat moving lengthwise back and forth over tubing. DO NOT TRAP AIR IN MIDDLE OF SPLICE KIT. When tubing has assumed the splice configuration and mastic seal is visible on each end of tubing, discontinue heating.

Klein Tools Pro Tone and Probe Electrical Wire Tracer Kit

This kit includes the tools necessary to tone and trace wires in common wiring systems. This premium tone generator has Angled Bed of Nails (ABN) clips that securely grip the cable. Tone Generator emits five distinct tones. An RJ11 plug easily connects to telephone or RJ45 data jacks for toning. The toner, also checks continuity and polarity that are indicated by clearly labeled LEDs. The probe traces with the tones signal. The adjustable-volume speaker amplifies the tone. The 3.5 mm jack allows for headphones (sold separately) to be attached in noisy environments. The probe has a tool-less non-metallic durable replaceable tip. The probe enables testing in distribution blocks without disturbing other services.

GARDNER BENDER Butt Splice Connector Kit 8-14 AWG; 1/Cd

Butt Splice Kit is used for waterproof repair of well pipe cables and splices of stranded cable #14 - #8 AWG. Connector set screws engage each wire for a secure splice. Assures safe and permanent connections. Easy to use polyolefin seals with heat gun or torch eliminating messy epoxies, tapes or mastics. Instructions: Slide heat shrink tubing over one conductor. Remove 5/8" insulation from conductors to be spliced. Insert stripped conductor in the butt splice. Tighten set screw to the lb per inch recommendations on the packaging and check for continuity of wire. Move heat shrink tube over splice and center. Heat tubing with torch or heat gun (MSTR-TORCH). Tubing shrinks at 350 F. Start in the middle of the tube, apply heat moving lengthwise back and forth over tubing. DO NOT TRAP AIR IN MIDDLE OF SPLICE KIT. When tubing has assumed the splice configuration and mastic seal is visible on each end of tubing, discontinue heating.

Klein Tools Scout Pro 3 Tester Kit

The Scout Pro 3 Tester Starter Kit is a versatile cable tester that locates and tests voice, data and video cables. Identify multiple cable runs with included location mapping remotes. This kit verifies accurate cable installations each time. Backlit display assists in reading results in lower light.