Paulin 1/8 x 3-inch Toggle Bolts - 16pcs

Paulin 3/8 x 3-inch Hex Head Lag Bolt - Hot Dipped Galvanized

Lag Bolts are also called Lag Screws and are recommended for all types of wood or metal to wood construction where standard wood or deck screws are too short or light and where nails or spikes lack sufficient strength. They can be installed in wood with pre-drilled pilot holes or in masonry with Lag Shields. In wood to wood applications the non-threaded shank allows the second piece to be drawn tightly to the first piece of wood. Flat or fender washers are suggested to provide a larger bearing surface and to prevent the head of the lag bolt from imbedding in the first piece of wood. Hot dipped galvanized finish provides one of the highest degree of corrosion resistance when compared to a steel zinc finish. Ideal for outdoor projects such as decks, fences, wood structures and with treated lumber installations.

Paulin 1/8-in x 3/4-in Round Head Square Drive Stove Bolt With Nut, Zinc-Plated, 18pcs

Paulin's Stove Bolts are machine screws that include matching hex nuts. These are fully threaded screws designed be used to fasten metal to metal, metal to wood and other types of materials. These screws are ideal fasteners for applications that may require future disassembly. They are also ideal where secure clamping of the materials is required. Zinc plating provides moderate corrosion resistance.

Paulin 1/4-20 x 1-1/2-inch Flat Head Square Drive Stove Bolts With Nuts, Plated Steel - 9 pcs.

Stove bolts are also known as machine screws. These screws are used to fasten metal parts together that are going into a tapped hole, or through a hole and being held by a nut. A nut of the same finish and threading for proper fit is included. Fasten with a screwdriver to reduce the risk of over-tightening, and to protect the screw and fastened material. To obtain the fastener length, measure from the underside of the head, to the tip of the screw. Made of steel, these screws are zinc-plated for moderate corrosion protection

Paulin 3/8 x 3-inch Carriage Bolt - Hot Dipped Galvanized - Grade 2 - UNC

Carriage Bolts are mostly used in wood or metal to wood applications with a domed top and a square body under the head. This square body pulls into the wood as the nut is tightened. When using carriage bolts always use a flat washer between the wood and hex nut to eliminate pull-through of the nut in the wood. Drill pilot hole slightly larger than body diameter of bolt. Insert the carriage bolt so the headed end is on finished side of project for appearance or safety. Length is measured from under head to end of bolt. Use hot dipped galvanized finish or stainless steel where corrorsion is and rust is of concern or for exterior applications. Hot dipped galvanized finish provides one of the highest degree of corrosion resistance when compared to a steel zinc finish. Ideal for outdoor projects such as decks, fences, wood structures and with treated lumber installations.